Materials Engineering and Management (B.Eng.Mgt.)

Admission to Level II Engineering Programs

Admission to Level II Engineering programs requires completion of all non-elective Engineering I courses with a minimum Grade Point Average (GPA) of 4.0. All programs have limited enrolment; should there be more applicants than the limiting number in any program, admission to that program will be based on a points system, computed as the product of the Fall-Winter Average and the number of units taken in the session (a minimum of 31 units will be used in the calculation). Students who do not meet the requirements to proceed to Level II in May will have a Pending flag put on their allocation. The Pending flag will be removed in August if the student completes the requirements over the summer.

In addition, admission to a B.Eng.Mgt. program requires the completion of ECON 1B03  with a minimum grade of 5.0; an interview may also be required.

Students admitted to a B.Eng.Society program are required to submit a statement indicating the educational objectives for the focus electives.

Students seeking admission to the Engineering and Management program, or the Engineering and Society program must first be admitted to the relevant department. Thereafter, they will be considered for admission to one of these two programs.

Notes

1. The Department of Materials Science and Engineering offers a common core with four streams of study in Levels III and IV. Students may complete the required units as listed in the calendar in Levels III and IV by choosing a course selection according to the following streams:
   
   • Nanomaterials MATLS 3Q03 , 4FF3 , 3 units from MATLS 4G03 , 4H03 
   • Metallurgy MATLS 4C03 , 4D03 , 4I03 
   • Polymer CHEM ENG 3Q03 , 4X03 , MATLS 4P03 
   • Electronic Materials ENG PHYS 3PN4 , MATLS 3Q03 , 4H03 
2. Note that a course in a stream may not be taught when the enrollment is (expected to be) too low.
3. Students entering Level II should register in the Materials Science and Engineering program and follow the requirements outlined below. Students entering Levels III, IV or V should follow the program requirements as specified in the Undergraduate Calendar of the year of their entry into Level II. Such students are advised to refer to their degree audit for the program in which they are registered and to consult with the Department of Materials Science and Engineering for further information.
4. As well as completing the academic requirements as specified in this Calendar, students in a Co-op program must complete ENGINEER 1EE0 .
5. Level V Materials Engineering and Management students interested in completing the Entrepreneurship Stream must apply to the Engineering and Management Program Office.

Requirements