Civil Engineering and Society (B.Eng.Society)

Admission to Level II Engineering Programs

Admission to Level II Engineering programs requires completion of all non-elective Engineering I courses with a minimum Cumulative Average (CA) of 4.0. All programs have limited enrolment; should there be more applicants than the limiting number in any program, admission to that program will be based on a points system, computed as the product of the Sessional Average (SA) and the number of units taken in the session (a minimum of 31 units will be used in the calculation). Students who do not meet the requirements to proceed to Level II in May will have a Pending flag put on their allocation. The Pending flag will be removed in August if the student completes the requirements over the summer.

In addition, admission to a B.Eng.Mgt. program requires the completion of ECON 1B03  with a minimum grade of 5.0; an interview may also be required.

Students admitted to a B.Eng.Society program are required to submit a statement indicating the educational objectives for the focus electives.

Students seeking admission to the Engineering and Management program, the Engineering and Society program, or the Engineering and International Studies program must first be admitted to the relevant department. Thereafter, they will be considered for admission to one of these three programs.

Notes

1. Students entering Level II will register in the Civil Engineering program following the requirements outlined below. Students entering Levels III, IV and V may continue in their existing stream and should follow the program requirements as specified in the Undergraduate Calendar of the year of their entry into Level II. Such students are advised to refer to their degree audit for the program for which they are registered in and to consult with the Department of Civil Engineering for further information.
2. As well as completing the academic requirements as specified in this Calendar, students in a Co-op program must complete ENGINEER 1EE0 .
3. Before the end of Level IV, students must complete a Civil Engineering electives form, and ensure that it has been approved by the Department before completing Level V Registration.
4. To meet the capstone project requirement, all students in their final level must take CIV ENG 4X06 . Qualified students may also take ENGINEER 4M06  with permission of the Chair or delegate. 
5. A minimum of 18 units of focus elective courses is required for the program. (This does not include the six units of complementary studies elective in Level I.)
6. Students entering Level V and continuing in the Water/Environmental Stream must take ENGINEER 4V04  as one of their technical electives.
7. International Studies Focus Electives Option: Students may choose to follow a set of recommended focus electives:
   • ANTHROP 1AB3 , RELIG ST 1B06 , POL SCI 2M03 , POL SCI 2XX3 , 3 units Focus Electives

Requirements