Mechanical Engineering and International Studies Co-Op (B.Eng.Society)

Admission to Level II Engineering Programs

Admission to Level II Engineering programs requires completion of all non-elective Engineering I courses with a minimum Cumulative Average (CA) of 4.0. All programs have limited enrolment; should there be more applicants than the limiting number in any program, admission to that program will be based on a points system, computed as the product of the Sessional Average (SA) and the number of units taken in the session (a minimum of 31 units will be used in the calculation). Students who do not meet the requirements to proceed to Level II in May will have a Pending flag put on their allocation. The Pending flag will be removed in August if the student completes the requirements over the summer.

In addition, admission to a B.Eng.Mgt. program requires the completion of ECON 1B03  with a minimum grade of 5.0; an interview may also be required.

Students admitted to a B.Eng.Society program are required to submit a statement indicating the educational objectives for the focus electives.

Students seeking admission to the Engineering and Management program, the Engineering and Society program, or the Engineering and International Studies program must first be admitted to the relevant department. Thereafter, they will be considered for admission to one of these three programs.

Notes

1. Level IV and Level V Mechanical Engineering and Society students must choose one of the following option areas and complete sufficient units of the listed required courses and technical electives.
   PROGRAM OPTION COMPULSORY COURSES:
   • General: five of any approved technical electives
   • Mechanics and Design: two approved technical electives; plus three of CHEM ENG 4T03 , ENGINEER 4T04 , MATLS 4T03 , MECH ENG 4B03 , 4BB3 , 4CC3 , 4E03 , 4H03 , 4I03 , 4K03 , 4L03 , 4T03 , 4Z03 
   • Manufacturing: two approved technical electives; plus three of CHEM ENG 4X03 , ENGINEER 4J03 , 4T04 , MATLS 4T03 , MECH ENG 4B03 , 4D03 , 4E03 , 4H03 , 4K03 , 4T03 , 4Z03 
   • Thermofluids and Energy Systems: two approved technical electives; plus MECH ENG 4S03 ; plus two of CHEM ENG 4X03 , MECH ENG 4I03 , 4J03 , 4O04 , 4T03 , 4U03 , 4W03   
   • Approved Technical Electives: any of the required courses listed above, plus CIV ENG 3K03 , COMMERCE 4QA3 , ENGINEER 3N03   
2. As well as completing the academic requirements as specified in this Calendar, students in a Co-op program must complete ENGINEER 1EE0 .
3. A minimum of 18 units of focus elective courses is required for the program. (This does not include the six units of complementary studies elective in Level I.)
4. Qualified students may take ENGINEER 4M06  in place of MECH ENG 4M06  with permission of the Department and Instructor.
5. International Studies Focus Electives Option: Students may choose to follow a set of recommended focus electives:
   • ANTHROP 1AB3 , RELIG ST 1B06 , POL SCI 2M03 , POL SCI 2XX3 , 3 units Focus Electives

Requirements